User's Manual

SAFETY INSTRUCTIONS
DERMALOG FLC1 User Guide 9 / 22
If transported by air, store the DERMALOG FLC1 in hermetic and heated compartments so that environmental
conditions comply with the technical data (see chapter 5).
STORAGE
The environmental conditions during storage must meet the conditions specified in the technical data section
(see chapter 5).
The air of the location where the DERMALOG FLC1 is stored must not contain corrosive or active substances.
3.4 Positioning and environment
Only use the DERMALOG FLC1 indoors.
Place the DERMALOG FLC1 on a suitable mount (e.g. a tripod) or a flat surface that is at room temperature.
Observe the recommended temperature range for the DERMALOG FLC1 to operate (see chapter 5).
Provide adequate space around the DERMALOG FLC1 for operation and maintenance. Air circulation is
required to cool the device. Do not restrict the air flow around the device.
Use the DERMALOG FLC1 only in a dry environment.
Keep the working environment always clean and dust-free.
Do NOT expose the DERMALOG FLC1 to:
 direct sunlight
 excessive dust, heat or humidity (for example, through a water heater or humidifier)
 an atmosphere where ammonia gas or volatile or flammable chemicals are present (for example,
alcohol, paint thinner)
 vibrations
 rapid temperature changes
 magnetic fields (for example, if placed near loudspeakers, televisions or radios)
3.5 Installation
Do not use a USB cable longer than 1.8 m. If you want to connect the DERMALOG FLC1 via a USB hub, always
use a self-powered (active) hub.
Connect the DERMALOG FLC1 only to suitable IT systems (see chapter 5).