Operation Manual

VIII User Manual Pedelec Xion 29
Remember that the motor carries additional weight
and the rear wheel is therefore heavier than normal!
Never hold or carry the rear wheel by the cable. This
poses the danger of the cable breaking.
6. On the le axle side of the motor, there is a detachable
component for torque support. Place this to one side,
so that it is not lost.
9 Removing and installing the rear
wheel
9.1 Removing the rear wheel
1. First, shi the bike chain to the smallest sprocket.
2. Then disconnect the cable between the motor and the
battery.
3. If your Pedelec is equipped with rim brakes,
unhook the brake cable at the brake body (➠ General
User Manual , Chapter 18.1 “Opening the brake”).
4. If your Pedelec is equipped with disc brakes, refer to
the section of the User Manual concerning the technol-
ogy featured in the bike for information on their han-
dling (➠ General User Manual , Chapter18.1 “Opening
the brake”).
5. Release the quick-release device (➠ General User Man-
ual, Chapter 9.2.2 “Operating the quick-release device”).
Then remove the rear wheel om the ame by rotat-
ing the rear derailleur backwards slightly, so that the
chainring can be fed past it more easily.
Disconnecting the cable