Operation Manual

FITTING THE ENGINE INTO
THE FRAME
- Follow the indications for stripping down as
given above, but in reverse order.
- Take care to ensure that the electrical con-
nections for the magneto, the spark plug,
and the engine temperature sensor are
correctly made.
- Install the fuel supply hose to the carburettor
and the vacuum line for the fuel cock, and in
addition the oil hoses from the oil reservoir to
the pump and from the pump to the carburet-
tor.
- Install correctly and ensure proper operation
of the throttle control and oil pump control
cables.
- Fill and bleed the oil pump (please refer to
the specific section in this manual).
- Install the clutch cable properly and adjust
for correct play using the tensioner at the
handlebar clutch lever.
- Refill the gearbox-clutch assembly and
check for correct level (please refer to the
specific section in this manual).
- Install the final drive chain, and take care to
ensure that the connector link and clip are
correctly secured.
- Fill the cooling circuit and bleed (please refer
to the specific section in this manual).
8-5