Operation Manual

36
ADJUSTING THE TIMING CHAÍN TENSION
1. Put the motorcycle on the centre stand.
2. Check:
- Drive chaIn tension (a).
Outside that specified => Adjust.
(distance between the chain guide and the furthest point
vertically)
Drive chain tension:
11 mm
3. Loosen:
- Axle nut (1) (both sides).
4. Loosen:
- Axle (2).
5. Adjust:
- Drive chain tension.
- Move the axle inwards or outwards using the bolt (3) until
the specified tension is obtained.
6. Tighten the axle nuts to the nominal torque.
Nut (rear wheel axle):
70-80 N.m (7-8 kgf.m)
JUS G G C SO