Operation Manual

ADJUSTING THE FRONT BRAKES

This machine is fitted with hydraulically activated disk brakes.

This type of brakes comes with adjustment factory set.

You must check that the brake fluid level is between the maxi-

mum and minimum.

N.B.

REMEMBER THAT THE LEVEL WILL BE AFFECTED BY THE DE-

GREE OF BRAKE PAD WEAR.

ADJUSTING THE REAR BRAKES

1. Check:

- Brake pedal clearance (a).

Outside that specified => Adjust.

Clearance:

5 - 10 mm

2. Adjust:

- Brake pedal clearance.

Adjustment steps:

Unscrew the nut (1):

Raise or lower the activator (2) to decrease or increase the

lever free clearance.

ATTENTION

ENSURE THAT THE BRAKES ARE NOT BINDING AFTER AD-

JUSTING THE PLAY.

INSPECTING THE BRAKE PADS

1. Apply the brake pedal or lever.

2. Inspect:

- Pads.

- Measure the brake pad lining thickness. If either of them is

below the service limit => Replace both pads.

Service limit (lining) => 1.5mm.

ADJUSTING

THE

FRONT

BRAKES

ADJUSTING

THE

REAR

BRAKES

Joc palanca fre

INSPECTING

THE

BRAKE

PADS