Operation Manual

137
3. Resistance of the spark plug connector
- Remove the connector.
- Connect the Multimeter (Ω x 1) to the spark plug connector.
N.B.
- ON REMOVING THE SPARK PLUG CONNECTOR, DO
NOT PULL IT WITH THE SPARK PLUG LEAD.
REMOVAL =>TURN IN AN ANTI-CLOCKWISE DIREC-
TION.
FITTING => TURN IN A CLOCKWISE DIRECTION.
- CHECK THE SPARK PLUG LEAD WHEN CONNECTING
THE CONNECTOR.
- ON CONNECTING THE CONNECTOR, CUT THE SPARK
PLUG LEAD BACK APPROCIMATELY 5MM.
Resistance of the connector
5KΩ ± 20% a 20°C
OUTSIDE THAT SPECIFIED
Renew the spark plug connector
3. Ignition coil resistance
- Disconnect the ignition coil connector from the electrical
system.
- Connect the Multimeter (Ωx 1) to the ignition coil.
- Check the resistance of the coil primary winding.
Resistance of the primary winding:
0.23 ± 20 % a 20°C
CONFORMS TO SPECIFICATIONS
Terminal (+) Spark plug side(1).
Terminal (-) Spark plug lead side (2).
Terminal (+) Green/Black Terminal (1).
Terminal (- Yellow/Green Terminal (2).