Operation Manual

115
INSPECTING THE REAR WHEEL
1. Inspect:
- Rear wheel axle
- Rear wheel
- Rear wheel bearings
- Retaining rings
See the “REAR WHEEL” section
2. Measure:
- Distortion of the rear wheel
See the “REAR WHEEL” section
FITTING THE REAR WHEEL
Reverse the “DISMANTLING” procedures. Take care with
the following points:
1. Fit:
- Rear wheel.
2. Adjust:
- Drive chain tension
See the “ADJUSTING THE DRIVE CHAIN” section in
“CHAPTER 3.
3. Tighten:
- Rear wheel axle.
- Axle nut (rear wheel) (1).
Nut (rear wheel axle):
110-130N.m (11- 13kgf.m)
4. Check:
- Brake pedal play
See the “ADJUSTING THE REAR BRAKES” section in
CHAPTER 3.
INSPECTING
THE
REAR
WHEEL
G