Technical data

213
Before you reassemble, wash all the components and conti-
nue with the following checks.
Flywheel cover: Check that there are no cracks or oxidation
on the seat of the ceramic seal. Check the capacity loads of
the bearings and of the seal ring. Check the efficiency of the
drain hole.
Shaft: Check to be sure there is no oxidation. Check that the
impeller is in perfect condition. Ceramic seal: Check that the
ceramic seals are not worn, cracked or scored. Check that
the two rubber seals are in perfect condition. Check the
thrust spring.
Bearings: Check that they do not have irregular plays or are
noisy.
Entrainment joint: Check that there is no abnormal wear on
the seat for the oil seal seat and on the slots for the entrain-
ment spring.