HD 2000 SIP Manual

9. Option 150--TFTP server address. (if you select SUPER OPTION->Upgrade Via-

>TFTP),

HTTP server address (if you select SUPER OPTION->Upgrade Via→HTTP)

9. SOFTWARE UPGRADE

To upgrade software, HD2000IP can be configured with a TFTP server where the new

code image is located. The TFTP upgrade can work in either static IP or DHCP mode

using private or public IP address. It is recommended to set the TFTP server address in

either a public IP address or on the same LAN with the HD2000IP.

There are two ways to set up the TFTP server to upgrade the firmware, namely through

voice menu prompt or via the HD2000IP’s Web configuration interface. To configure the

TFTP server via voice prompt, follow section 8.1, once set up the TFTP IP address, power

cycle the HD2000IP, the firmware will be fetched once the HD2000IP boots up.

To configure the TFTP server via the Web configuration interface, open up your browser to

point at the IP address of the HD2000IP. Input the admin password to enter the

configuration screen. From there, enter the TFTP server address in the designated field

towards the bottom of the configuration screen.

Once the TFTP server is configured, please power cycle the HD2000IP.

TFTP process may take as long as 1 to 2 minutes over the Internet, or just 20+ seconds if

it is performed on a LAN. Users are recommended to conduct TFTP upgrade in a

controlled LAN environment if possible. For those who do not have a local TFTP server,

DEPAEPE provides a NAT-friendly TFTP server on the public Internet for firmware

upgrade. Please check the Service section of DEPAEPE’s Web site to obtain this TFTP

server’s IP address.

NOTES:

When DEPAEPE IP Phone boot up, it will send TFTP or HTTP request to download

configuration files, there are two configuration files, one is “cfg.txt” and the other is

“cfg001fc1xxxxxx”, where “001fc1xxxxxx” is the MAC address of the HD2000IP . These

two files are for initial automatically provisioning purpose only, for normal TFTP or HTTP

firmware upgrade, the following error messages in a TFTP or HTTP server log can be

ignored.