HD_2000_Urgence_-_FR_-_EN_-_2020

Settings programming
Note: HD2000 Urgence standard factory settings come with:
-Programming access code= 0000
-Dialling = Tone
-Hook
-Flash duration = 270 ms
-Pulse mark-break ratio = 66/33
-Access to memory programming = unlocked
-Call barring = unlocked
To change settings, proceed as follows:
1) Make sure the telephone is connected to a powered C.O. or PABX line.
2) Depress «PGR» key located on the small keypad (Located at the back of the unit).
3) While keeping «PGR» key depressed, pick-up the handset.
4) Release «PGR» key.
5) 2 sharp «beep» tones will confirm entering the settings programming mode.
6) Enter the 4 digits programming access code with the keypad (factory pre set code is:
0000)This code can be modified (see «LIST OF SETTINGS» section, pages 24-25).
7) If the right code is entered, 2short «beep» tones will be heard and the access to
settings, changes will be authorized.If a wrong code is entered, a low «beep» tone will be
heard and the unit will return to talk mode.
8) Enter the 2 digits selected setting access code (see «LISTOF SETTINGS» section
pages 24-25)
9) 2 sharp «beep» tones confirming the selection will be heard.
10) Enter your custom setting choice or the code or number to store.
11) Terminate your setting by depressing «PGR» key. 22
12) 2 sharp «beep» tones will confirm the storage of your new setting.
13) For other settings, proceed with operations 2 up to 11.
22