HD_2000_Urgence_-_FR_-_EN_-_2020

Mode 1-HD2000 Urgence 1 programming and Urgence à clavier (Automatic off-hook

dialling):

1) Make sure HD2000 Urgence is connected to the line.

2) Lift the handset.

3) Depress "PGR" key located on the small keypad (Located at the back of the unit).A

"beep" sound should be heard through the receiver.

4) Depress "P" (Pause) key located on the small keypad.A "beep" sound should be heard

through the receiver.

5) Dial the telephone number to store including *, # or "Pause" if needed (22 digits maxi).

6) Press “MX” key.A double "beep" sound confirms the right storage.

7) Replace the handset on hook.

NOTE: In case of wrong operation, a long "beep" sound is emitted. Replace the handset

on hook and start again from the beginning.

NOTE: To erase a number stored in memory, proceed from 1 to 4, skip section 5 (Do not

enter any digit) and terminate as in 6 and 7.

NOTE: HD2000 Urgence 1 and Urgence à clavier factory settings come with “Urgence“

mode. In case of wrong operation, see «LIST OF SETTINGS» pages 24-25 and check that

“Urgence” mode is selected.

Setting access code : 04

Setting choice Urgency:1