Data Sheet

Bluetooth Module NDB1793S02datasheet Ver1.0

第 8 页（共 8 页）
FCC statement
FCC Label: The FCC ID is on the front of the device. It is easily visible.
The device FCC ID is 2ATO2-NDB1793S.
A label with the following statements must be attached to the host end product:
This device contains FCC ID: 2ATO2-NDB1793S.
The manual provides guidance to the host manufacturer will be included in the documentation that will be
provided to the OEM.
The module is limited to installation in mobile or fixed applications.
The separate approval is required for all other operating configurations, including portable configurations
and different antenna configurations.
The OEM integrators are responsible for ensuring that the end-user has no manual or instructions to
remove or install module.
Module grantee (the party responsible for the module grant) shall provide guidance to the host
manufacturer for ensuring compliance with the Part 15 Subpart B requirements.
The host manufacturer is responsible for additional testing to verify compliance as a composite system.
When testing the host device for compliance with the Part 15 Subpart B requirements, the host
manufacturer is required to show compliance with the Part 15 Subpart B while the transmitter module(s)
are installed and operating. The modules should be transmitting and the evaluation should confirm that
the module’s intentional emissions are compliant (i.e. fundamental and out of band emissions) with the
Radio essential requirements. The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in the Part 15 Subpart B or emissions are complaint
with the Radio aspects.
FCC RF Exposure Requirements
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter and must be installed to provide a separation distance of at least 20cm from all
persons.
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference