User Manual
19
● There will be no light on the charger before charging, when connected to e-scooter the adapter will
light red, and charging has started.
● When fully charged. It will show Green light and after some time the will turn off.
● Now you can stop the charging cycle. Overcharge shortens the battery life.
● The charging process takes up to 4.5 hours. Do not charge the battery for more than 4.5 hours.
After 4.5 hours, disconnect the charger from the device and the power supply. Overcharge reduces
the battery service life.
● The product must not be charged over extended periods.
● Always keep an eye on the device throughout the charging cycle.
● Charge the device only at temperatures between 0 °C and +45 °C.
● When charging at lower or higher temperatures, there is a risk that the battery performance will be
reduced. Therefore, there is a potential risk of injuries and material damage.
● Store and charge the device in an open, dry area away from combustible materials.
● Do not charge the device in direct sunlight or in the vicinity of open flames.
● Do not charge the device immediately after use. Allow the device to cool down for an hour before
charging it.
● The device is generally partially charged as shipped from the factory. Keep the device partially
charged until it is used.
● Allow the Electric scooter to cool down for at least 1 hour before it can be put in the package.
● Do not leave the device exposed to sunlight in a car.
CAUTION
The Electric scooter must not be used during the charging cycle!
● The LED indicator on the battery charger lights red during the charging process.
● The LED indicator on the charger will light green when the charging process is complete.
● After charging, disconnect the charger from the mains and the Electric scooter.
CAUTION
Connect the DC cable supplied with the Electric scooter only to the DC input!
● Do not insert foreign objects into the DC input.
CAUTION
● Do not remove the protective cap from the DC input!
● Remove the cap only when charging the Electric scooter!
● After charging, disconnect the DC plug and close the DC input again with the cap!
WARNING
Make sure that neither water nor other liquids penetrate into the inner components of the Electric
scooter; otherwise, the electronics/batteries of the device could be permanently damaged. There is a
risk of injury.