Operating instructions

ENG-10
- INCLUDED 1 PC STAND FOR THE MAIN UNIT ( )
FIXING THE BASE TO THE UNIT:
WHEN THE
INDICATOR MARK
ON THE STAND
IS ALIGNED
WITH THE LOCK
SYMBOL , THE
BASE IS
PROPERLY
IS PROPERLY
INSTALLED.
SYSTEM SET UP PROCEDURE
A. AS A "SHELF SYSTEM" (TABLE TOP USE)
1. PLACE THE STAND UNDER
THE UNIT.
2. SLIDE THE STAND UPWARD
(SEE DIAGRAM BELOW).
3. STOP WHEN THE INDICATOR MARK ON THE STAND IS ALIGNED WITH
THE LOCK SYMBOL ON THE REAR CABINET.
(TO RELEASE THE STAND FROM THE UNIT , SLIDE THE STAND DOWNWARDS
(OPPOSITE DIRECTION) UNTIL IT BECOMES RELEASED.
CLICK
LOCKED
INDICATOR MARK
LOCK SYMBOL
ENG-9
CONNECTING AN EXTERNAL POWERED SUBWOOFER
(NOT INCLUDED)
- THIS UNIT HAS A BUILT IN SUBWOOFER CONNECTION WHICH CAN BE CONNECTED TO
ANY STANDARD POWERED SUBWOOFER.
- BY CONNECTING TO A POWERED SUBWOOFER, THE LOW FREQUENCY (BASS SOUND)
CAN BE STRONGLY ENHANCED TO PROVICE A MUCH RICHER AND DEEPER SOUND TO
YOUR MUSIC.
- TO USE THIS FACILITY, SIMPLY CONNECT ANY STANDARD POWERED SUBWOOFER
(EASILY AVAILABLE FROM MOST MUSIC EQUIPMENT SHOPS) USING THE RCA JACK ON
THE REAR PANEL OF THE MAIN UNIT.
- SWITCH ON THE POWERED SUBWOOFER.
- PLAY ANY MUSIC SOURCE (CD or RADIO or AUX) AS USUAL.
- YOU WILL IMMEDIATELY NOTICE THE DEEPER SOUND, WHICH CAN BE FURTHER
ENHANCED BY SWITCHING ON THE "SUPER BASS" FUNCTION ON THE MAIN UNIT.
- PLEASE NOTE THAT "PASSIVE" (NON-POWERED) SUBWOOFERS WILL NOT WORK WITH
THIS UNIT.
SPECIFICATIONS
POWER SUPPLY : ......................................... AC 230V ~ 50 Hz
POWER CONSUMPTION : ............................. 25W
SPEAKER : ..................................................... 3½" x 2
FREQUENCY : ............................................... AM 522 - 1620 kHz
FM 87.5 - 108 MHz
BATTERY SHALL NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE,
FIRE OR THE LIKE.
THE APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO
OBJECTS FILLED WITH LIQUIDS SHOULD BE PLACED ON THE APPARATUS.
THE MARKING AND RATING LABEL IS LOCATED AT REAR ENCLOSURE OF
THE APPARATUS.
THE MAINS PLUG IS USED AS THE DISCONNECT DEVICE AND IT SHALL REMAIN
READILY OPERABLE. TO BE COMPLETELY DISCONNECTED THE POWER INPUT,
THE MAINS PLUG OF THE APPARATUS SHALL BE DISCONNECTED FROM
THE MAINS COMPLETELY. THE MAINS PLUG SHOULD NOT BE OBSTRUCTED OR
SHOULD BE EASILY ACCESSED DURING INTENDED USE.
UNDER THE INFLUENCE OF ELECTROSTATIC PHENOMENON,
THE PRODUCT MAY MALFUNCTION AND USER TO POWER RESET.
EXCESSIVE SOUND PRESSURE FROM EARPHONES AND HEADPHONES CAN
CAUSE HEARING LOSS.
CAUTION
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.