User manual

First Time Installation
Enter your regional settings, include your Country, Language, Time Zone.
Please change the country settings in order to your active country. Then select
<NEXT> to proceed.
Please navigate to <YES> and confirm by pressing the ENTER button. Than
the Auto search starts.
Note: The previous channel list will be deleted and replaced by the new one.
After all the connections have been made properly, switch on your TV. Make
sure the receiver is connected to the mains and press <POWER> to switch the
receiver on. If you are using the receiver for the first time, a First Time
Installation menu will be displayed to guide you through the initial setup. Use
the remote controller to finish the setup.
At the First time installation menu, select <YES> and press ENTER button on
the remote controller to proceed.
Please press the TV button on the remote control to appear the menu, where you
can change to DVB. Navigate with the UP or DOWN button the DVB and activate
DVB by pressing the ENTER button.
If you use DVB-T the first time, than the system entered to the First Time Installation.
-8-
TV Installation Menu