User Manual

POWER SUPPLY
OPERATING THE UNIT ON AC POWER
Insert one end of the supplied power cord into the 6V DC socket located at the
rear of the unit and the other end into the wall outlet.
OPERATING THE UNIT ON BATTERY POWER
1. To run your unit on battery power, the AC power cord must be disconnected
from the product.
2. Unplug the AC power cord from the unit and insert 4 size “AA” batteries (not
provided) into the compartment.
DAB Radio mode
Press MODE until you are in DAB mode.
The first time you use the Radio or if the station list is empty, your radio will
automatically begin to scan for DAB radio stations. A progress bar will be shown,
and the number of stations found during the scan will also be displayed.
Changing DAB stations
Press TUNE +/ TUNE - to scroll through the available stations.
When the station that you would like to listen to is displayed, press
SELECT/SNOOZE to select.
Manual scan In DAB mode:
Press PLAY/SCAN to begin a search for stations. The display will change to
‘Scanning...’ A progress bar will be shown, and the number of stations found
during the scan will also be displayed.
FM Radio mode
Press MODE to go to FM mode.
Tuning into an FM station
Press and hold TUNE + for 2 seconds to scan up the frequency band.
Press and hold TUNE - for 2 seconds to scan down the frequency band.
Press TUNE +/ TUNE - to fine tune each frequency in 0.05MHz steps.
Storing a DAB and FM station preset
Your Radio can store up to 20 DAB and 20 FM radio stations.
1. Tune the Radio to the station that you wish to preset.
2. Press and hold PRESET for approximately 2 seconds until <Preset Save> is
displayed.
3. Use TUNE +/ TUNE - to move to the preset location that you would like to use
to store the radio station (1-20).
4. Press SELECT/SNOOZE, the display will confirm Preset X Saved, where ‘X’ is
the number of the preset (1-20).
Note: Any existing station already stored under a preset will be overwritten
when you store the new station.
ENG 4