User Manual

ManualsBrandsDenver Manualsalarm clocksCRD-505

1. Speaker

2. ALARM button (1/2)

3. < button

4. > button

5. MENU / INFO / BACK button

6. VOLUME UP button

7. VOLUME DOWN button

8. SELECT button

9. PRESET button

10. SNOOZE/ SLEEP/ DIMMER button

11. SOURCE button

12. POWER / ALARM OFF button

13. Display

14. Antenna

15. USB charging port

16. DC IN jack

Display

1. Volume

2. Alarm 1 icon

3. Alarm 2 icon

4. DAB mode

5. FM mode

6. Sleep mode / Snooze mode

7. Signal

8. Time/Frequency/Message

Listening to DAB broadcasts

1. Press the POWER button to turn the radio on.

2. Press the SOURCE button to select DAB mode. The DAB mode icon shows on the display.

** Please note that the DAB radio signal can be much weakened. This depends on the type of

terrain you’re driving in. For example, buildings, hills, mountains, etc. can make it difficult to get a

good DAB radio signal. Please check your local DAB radio provider to find out the best DAB radio

signal coverage in your country.

Scanning for DAB stations

The first time you use the radio, or if the station list is empty, the radio automatically performs a

station search.

To perform a station search manually:

1. In DAB mode, press and hold the MENU button until you see “STATION SCAN” on the display.

2. Press the SELECT button.

3. Press the < or > button to select “FULL SCAN” or “MANUAL TUNE”.

Summary of content (5 pages)

PAGE 1
. Speaker 2. ALARM button (1/2) 3. < button 4. > button 5. MENU / INFO / BACK button 6. VOLUME UP button 7. VOLUME DOWN button 8. SELECT button 9. PRESET button 10. SNOOZE/ SLEEP/ DIMMER button 11. SOURCE button 12. POWER / ALARM OFF button 13. Display 14. Antenna 15. USB charging port 16. DC IN jack Display 1. 2. 3. 4. 5. 6. 7. 8. Volume Alarm 1 icon Alarm 2 icon DAB mode FM mode Sleep mode / Snooze mode Signal Time/Frequency/Message Listening to DAB broadcasts 1.
PAGE 2
4. FULL SCAN: To perform a wide range search for DAB stations and store them automatically. MANUAL TUNE: Press the < or > button to tune the frequency manually. Press the SELECT button to confirm the selection. Tuning to a DAB station 1. 2. In DAB mode, press the < or > button to cycle through the DAB stations in the station list. Press the SELECT button to tune to the selected DAB station. Storing preset stations You can store up to 20 DAB stations as preset stations. 1. Tune to a DAB station. 2.
PAGE 3
This setting defines the volume of the alarm. The alarm setting is now saved. When the alarm setting is active (ON), the corresponding alarm icon (1 or 2) shows on the display. At the set time, the alarm will ring. The volume will increase gradually until it reaches the set volume level. The corresponding alarm icon will flash on the display. Turning off the alarm settings 1. Press the ALARM button to select between Alarm 1 and Alarm 2 and then press the SELECT button to confirm the selection. 2.
PAGE 4
Specifications Tuner Range Number of preset radio stations Ampliﬁer Rated Output Power Adaptor Manufacturer’s name Commercial registration number Adaptor Model number Input voltage Input AC frequency Output voltage Output current Output power Average active efficiency Efficiency at low load (10%) No-load power consumption FM: 87.5 – 108 MHz DAB: 174.928 - 239.200 MHz 20 (FM), 20 (DAB) 2.0 W (RMS) DongGuan Obelieve Electronic Co., Ltd. 91441900050747698U OBL-0501500E AC 100-240 V 50/60 Hz, 0.3 A max. 5V 1.
PAGE 5
Please notice - All products are subject to change without any notice. We take reservations for errors and omissions in the manual. ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly.