DENVER CRP-718 ENGLISH FUNCTION AND CONTROLS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. SNOOZE / SLEEP / DIMMER DISPLAY PM INDICATOR STANDBY INDICATOR ALARM 1 INDICATOR ALARM 1 ON / OFF SET ALARM 2 ON / OFF SET << / TUNE - / YEAR/MONTH/DAY / C-F >> / TUNE + / DST VOLUME DOWN / DISPLAY LIGHT AUTO ON-OFF VOLUME UP / TOGGLE BETWEEN DISPLAY CONTENTS ONOFF CLOCK ADJ. / MEM.
LED DISPLAY MODE TIME POWER CONNECTION Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery back up system, it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in the battery compartment, making certain that the positive and negative (+ and -) battery terminals are attached to the corresponding terminals on the plate in the battery compartment.
TIME AND CALENDAR MANUAL SETTING Setting Time and Calendar Press Clock ADJ. (12) button in standby mode and keep depress over 2 seconds to enter time set mode, after enter the setting mode, press Clock ADJ. button (12) to change the mode cycle as follows: Normal → Year → Month → Day → 12/24 H format → Real time Hour → Real time Min → Normal Action (during data adjustment): - Press << / Tune - button (8) to adjust data backward. - Press >> / Tune + button (9) to adjust data forward.
Action (during data adjustment): - Press << / Tune - (8) button to adjust data backward. - Press >> / Tune + (9) button to adjust data forward. - Keep depressed << or >> button for 2 seconds to enable auto forward. - Use ALARM 1 / ALARM 2 set button to confirm each setting. ALARM Beep alarm or radio alarm will ring for 30 minutes if no key is pressed, then it will stop automatically and wait for same alarm time on next day.
DIMMER CONTROL The dimmer button (1) allows you to set the brightness of the LED display to high, medium and low 3 levels. DISPLAY LIGHT AUTO ON/OFF FUNCTION 1. Press display light auto on-off button (10) for 3 seconds, the LED display indicator will light on, the LED display will turn off after 15 seconds automatically. Press any button to maintain the LED display for 15 seconds. 2. Press display light auto on-off (10) button for 3 seconds, the LED display indicator will light off to cancel this function.
to the clock mode. TIME Contents in 10-second intervals Contents in 5-second intervals Contents in 5-second intervals Contents in 5-second intervals RADIO MODE Note: Ensure that the FM antenna is completely unrolled and extended to have the best FM reception. 1. Press the Radio ON/OFF button (13) to turn the unit on. 2. Use the Tune - (8) or Tune + (9) button to select the desired radio station.
4. Use the Tune+ or Tune- button to select the desired preset station (P01-P10) 5. Press the memory / memory + button again to set the preset. 6. Repeat steps 2 through 5 to set more presets. 7. The unit can preset 10 stations totally for FM. 8. When “P01-P10” is blinking, press the Tune+ or Tune- button to select the preset number. 9. When recalling preset stations, press memory / memory + button to select the preset number.
Weather station predicts possible weather, thus symbols could not agree with current weather. Forecast: SUNNY for night means cloudless sky. Humidity sensor specification: Operating temperature range : 10 ~ 50ºC Operating humidity range : 30 ~ 95% If temperature is below 10ºC or higher than 50ºC, The LED display will show - - % for humidity and not show the weather forecast.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S www.denver-electrionics.com Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen below.
SVA PRAVA SU ZADRŽANA, AUTORSKA PRAVA DENVER ELECTRONICS A/S www.denver-electrionics.com Električna i elektronička oprema sadrže materijale, komponente i tvari koji mogu biti opasni za vaše zdravljei okoliš ako se otpadni materijal (odbačena električna i elektronička oprema) ne odlože na propisani način. Električna i elektronička oprema i baterije su označene prekriženim simbolom otpada, kako je viđeno gore.
