Specifications

497
Appendices
*13
You can set the communications protocol type for transmitting files with the XFILE state-
ment.
*14
You may set the BHT’s ID number to be used for the BHT-Ir protocol. The ID number is
expressed by two bytes: lower byte on port 6061h and upper byte on port 6062h. The set-
ting range is from 1 to FFFFh. To set the ID number to 1234h, write as follows:
OUT &h6061h,&h34 ’Sets 34h to the lower byte of the ID
OUT &h6062h,&h12 ’Sets 12h to the upper byte of the ID
*15
For data transmission via the optical interface, this bit sets the output pulse width of IR
beam in accordance with the IrDA physical layer (IrDA-SIR 1.0). The default width is 1.63
µs.
*16
If you set 0 (standard-size) to this bit, characters will be displayed as follows:
If you set 1 (small-size) to this bit, characters will be displayed as follows:
*17
Supported by the BHT-6500 only. If you set 0 (Deactivates) to both bits 0 and 1, only the
beeper will work.
(W) x (H)
Single-byte ANK mode 6 dots x 8 dots
Two-byte Kanji mode Full-width
Half-width
16 dots x 16 dots
8 dots x 16 dots
(W) x (H)
Single-byte ANK mode 6 dots x 6 dots
Two-byte Kanji mode Full-width
Half-width
12 dots x 12 dots
6 dots x 12 dots