Specifications

267
• Specification of the maximum value to
column moves the cursor off the screen
and out of sight.
Example: Single-byte ANK mode in the BHT-3000
If you display data on the screen under the above condition, the cursor moves to
the 1st column of the next row, from where the data appears.
• In the BHT-4000, if the system status indication is set to ON, the cursor cannot
move to the bottom line of the LCD. If you specify the bottom line, the cursor will
move to the next to the bottom line instead.
• In the BHT-5000/BHT-6000/BHT-6500, if you specify the right end of the bottom
line as the desired cursor position when the system status is displayed, the cur-
sor becomes invisible.
• If some parameter is omitted, the current value remains active. If you omit
col-
umn
, for example, the cursor stays in the same column but moves to the newly
specified row position.
• Any parameter value outside the range will result in a run-time error.
• The column range does not differ between the normal- and double-width charac-
ters.
Run-time errors:
Example:
LOCATE 1,2
LOCATE xPos,xCSRLIN
LOCATE ,,2
Reference:
Error code Meaning
05h
Parameter out of the range
Functions:
CSRLIN and POS
LOCATE 17
← Cursor