User`s manual

BHT-604BW

 BHT-BASIC4.0 Transfer Utility

Transfers files between the host computer and BHT at the host computer.

YMODEM or BHT-Ir protocol is used for file transfer.

BHT-BASIC 4.0 specification files such as application programs and data files are transferred using

YMODEM protocol.

 BHT-PC Cable (RS-232C)

This cable can be used to connect the BHT and computer using the BHT connector interface and

computer RS-232C interface.

(Note) The BHT connector interface has not been designed for frequent removal and insertion of the

cable. The CU-600 Series should normally be used. Refer to “Chapter 5 Communication” - “5.1

Connector Communication (RS-232C Interface)” for details on the connector interface.

 BHT-BASIC4.0 Transfer Utility (Option)

This is the same BHT-BASIC 4.0 Transfer Utility that comes bundled with the BHT-BASIC 4.0

Development Pack.

[3] Software Used at the BHT Unit

The BHT unit FLASH memory has a system area and

user area, with the system program stored in the

system area and font files and user programs stored in

the user area.

The BHT unit i

s shipped with the system program and font

files stored in their respective areas.

Host computer

Applicatio

n programs (*.PD4) stored in th

e user area are run by the system program in order to use the

BHT.

It is necessary to download application programs (*.PD4) and data files (product master files etc.) required

to run application programs (*.PD4) to the BHT user area prior to use.

 System Program

 Driver

Drivers is a set of programs that directly controls the BHT hardware. It can be called up by the

BHT-BASIC Interpreter or System Mode.

 BHT-BASIC Interpreter

This program interprets application program (*.PD4) command language and controls the BHT unit

hardware via drivers.