User`s manual

45
Chapter 2. Getting Started the BHT-5000 and System Mode
On the protocol setting screen ("2: Protocol" has been selected)
Selecting "2: Protocol" on either of the SET COM
OPTICAL and SET COM CONNECTOR menus calls
up the screen as shown at left.
Reversed is the current setting.
1 Serial No. : Selects whether or not the sys-
tem should add serial numbers
to data blocks.
2 H. Parity : Selects whether or not the sys-
tem should add a horizontal par-
ity.
3 RS/CS : Selects whether or not the sys-
tem should control the RS/CS sig-
nal.
4 Timeout : Selects the timeout length (in sec-
onds) to be applied when a link
will be established.
5 Last Space : Selects whether space codes in
the tail of a data field should be
ignored or handled as data.
Select a desired item by using the numerical keys
or
* and
* keys, and then select a desired
setting by using
* and
* keys.
To return to the SET COM OPTICAL or SET COM
CONNECTOR menu, press C key.
"5: Last Space" allows you to determine
how to handle space codes placed in the
tail of a data field when downloading
data files. If you select "Ignore," those
space codes will be eliminated; if you
select "Data," those will be handled as
data. For details, refer to the "BHT-
BASIC 3.0 Programmer's Manual," Ap-
pendix G.
SET COM PROTOCOL
1:Serial No: ON OFF
2:H.Parity : ON OFF
3:RS/CS : ON OFF
4:Timeout :
30 60 90 120 NONE
5:Last Space:
Ignore Data
REFERENCE
* For BHT-5000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of
,
,
, and
keys, respectively