User`s manual

33
Chapter 2. Getting Started the BHT-5000 and System Mode
Selecting "2: Download" on the SYSTEM MENU
calls up the screen shown at left.
1 DRIVE A : Downloads a user program
file (object file compiled by
the BHT-BASIC 3.0 Compiler)
or data file
to the RAM .
2 DRIVE B : Downloads a user program
file (object file compiled by
the BHT-BASIC 3.0 Compiler)
or data file
to the flash ROM .
3 HT<-->HT COPY : Downloads all of the files,
system parameters, and cal-
endar clock data stored in
the connected BHT-5000.
This function enables copy-
ing between the BHT-5000s.
For the preparation to be
made preceding the start of
this function, refer to
NOTE
below.
Select a desired item by using the numerical keys
or
* and
* keys, and the selected item be-
comes reverse-displayed. Then press ENT key.
[ 2 ] Downloading
If you download a file having the same name as that already used in the user area of
the target memory in the BHT-5000, the newly downloaded file replaces the old
one.
NOTE
⇓
DOWNLOAD
1:DRIVE A
2:DRIVE B
3:HT<-->HT COPY
NOTE Preparation for Copying between the BHTs
Before downloading to the BHT-5000 from another BHT-5000, make the fol-
lowing preparation:
Via the direct-connect interface
•At each BHT-5000, run System Mode and select the direct-connect interface
port. (On the SYSTEM MENU, select "4: Set System," "5: Communication," and
"3: Default." Then, on the SET COM DEFAULT screen, select "Connector" of "2:
SYSTEM MODE.")
• Pull out the connector cover on each BHT-5000 so that the direct-connect inter-
face port will be exposed, and then use the direct-connect interface cable
(having 3-pole mini stereo plugs) to connect them directly. (For the details on
the cable, refer to Chapter 3, Subsection 3.1.2.)
• On the uploading BHT-5000, run System Mode and select "3: Upload" and "5:
HT<-->HT COPY."
Via the optical interface
• Connect two CU-5000s with each other by using an RS-232C cross-mode cable.
•At each BHT-5000, run System Mode and make sure that the optical interface
(default) is selected. (If the direct-connect interface is selected, on the SYSTEM
MENU, select "4: Set System," "5: Communication," and "3: Default." Then, on
the SET COM DEFAULT screen, select "Optical" of "2: SYSTEM MODE.")
• On the uploading BHT-5000, select "3: Upload" and "5: HT<-->HT COPY."
* For BHT-5000s having a 26-key pad, use F5 and F6 keys instead of
and
keys,
respectively