User`s manual

2.3 Preparation

2.3.1 Setting-up 1: Loading the Battery Cartridge

Before starting the BHT-5000, be sure to load the battery cartridge (sold separately)

according to the steps below.

(1) For the Ni-MH battery cartridge: Charge the battery cartridge, referring to Section

5.5, "Charging the Ni-MH Battery Cartridge (using the CU-5001)."

For the dry battery cartridge: Load two LR6 batteries into the cartridge, referring

to the "User's Manual of Dry Battery Cartridge" contained in the battery cartridge

package.

(2) Turn the BHT-5000 upside down.

(3) Push the battery cartridge into the BHT-5000 until it clicks into place. (To remove

the battery cartridge, press the release button.)

Release button

Battery cartridge

CAUTION

• Do not use batteries or power sources other

than the specified ones; doing so could gener-

ate heat or cause malfunction.

WARNING

• Never disassemble or heat the battery cartridge,

nor put it into fire or water; doing so could

cause battery-rupture or leakage of battery fluid,

resulting in a fire or bodily injury.

• Do not carry or store the battery cartridge to-

gether with metallic ball-point pens, necklaces,

coins, hairpins, etc.

Doing so could short-circuit the terminal pins,

causing the batteries to rupture or the battery

fluid to leak, resulting in a fire or bodily injury.

• Avoid dropping the battery cartridge or letting

it undergo any shock or impact.

Doing so could cause the batteries to break,

generate heat, rupture or burn.

• Never charge the Ni-MH battery cartridge where

any inflammable gases may be emitted; doing

so could cause fire.