User`s manual

110
5.4.2 Interfacing with the Host Computer
(1) Power on the host computer and start up the MS-DOS.
(2) Turn on the power switch of the CU-5000.
(3) Make sure that the BHT-5000 is turned off, then put it on the CU-5000.
(4) Power on the BHT-5000 and run System Mode.
(5) Initiate a communications program (e.g., Transfer Utility and System Loader) in
the host computer.
(6) To transfer data stored in the BHT-5000 to the host computer, select "3: Upload"
on the SYSTEM MENU in System Mode. To transfer data from the host computer
to the BHT-5000, select "2: Download" on the SYSTEM MENU. (For details, refer
to Chapter 2, Section 2.4.)
The BHT-5000 and the host computer will start communications with each other
via the CU-5000. Upon start of communications, the DATA LED of the CU-5000
will come on.
After completion of communications, the DATA LED will go off.
(7) Power off the BHT-5000, CU-5000, and the host computer.