User`s manual
iv
Handling the scanner
Wrong handling of the battery cartridge could result in a heat, smoke, explosion, or fire. Be sure to
observe the following
The scanner uses a laser light for indicating
the scanning range. The intensity of laser
light might be too low to inflict bodily injury.
However, do not stare into beam.
The scanner complies with IEC 60825-1
Ed.2:2007.
In accordance with Clause 5 and 6, IEC
60825-1, the following information is provided
to the user:
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Caution – Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
If smoke, abnormal odors or noises come from the scanner, immediately remove the battery
cartridge and contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
If foreign material or water gets into the scanner, immediately remove the battery cartridge and
contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
If you drop the scanner so as to affect the operation or damage its housing, remove the battery
cartridge and contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
Do not use the scanner where any inflammable gases may be emitted.
Doing so could cause fire.
Do not subject the scanning window of the scanner to direct sunlight for extended periods.
Doing so could damage the scanner, resulting in a fire.
Never bring any metals into contact with the terminals in connectors.
Doing so could produce a large current through the scanner, resulting in heat or fire, as well as
damage to the scanner.
Stop charging if it cannot be completed within the specified time.
Never put the scanner into a microwave oven or high-pressure container.
Doing so could cause the batteries to break, generate heat, rupture or burn.
Never use the scanner on the line voltage other than the specified level.
Doing so could cause the charger to break or burn.
Use the dedicated battery cartridge only.
Failure to do so could result in fire.