Specifications

[Issue No.] GOT-A-0010-S [Page] 15/28
[Title] List of Valid Devices Applicable for GOT1000 Series
[Date of Issue] Ver.S: December 2010 (First Edition: September 2005)
[Relevant Models] GOT1000 Series
HEAD OFFICE : TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
NAGOYA WORKS : 1-14, YADA-MINAMI 5-CHOME, HIGASHI-KU, NAGOYA, JAPAN
TECHNICAL BULLETIN
6. Printer
Only for the GT16 and the GT15, PictBridge compatible printers and serial printers are available.
6.1 PictBridge compatible printer
By mounting the printer unit (GT15-PRN) on the GT16 or the GT15, a PictBridge compatible printer is available.
For the printer unit (GT15-PRN), only PictBridge compatible printer is connectable.
To use a PictBridge compatible printer, GT Designer2/GT Works2 Version2.27D
or later, or GT Designer3
Version1.01B or later is required.
Precautions
PictBridge compatible printers are available, however the paper size, print area, or corrective actions for errors
vary according to the type of the model. For details, follow the printer manual.
(1) Paper size
Regardless of the paper size set on the GOT, an image on the GOT may be printed at the size set on the
printer.
When the paper size of the hard copy is specified other than the A4 size, an error may occur and the hard copy
cannot be printed. Set the paper size to A4.
(2) Printable area
When using the report function of the GOT, the printable area varies according to the printer.
By the printer specifications, the trimming process is performed and some specified lines may not be printed.
(The trimming process adjusts image dimensions to a full printable area specified for the paper size, and does
not print the unprintable areas.)
When some areas are not printed, adjust margins and lines by using the report function of the GOT in
accordance with the printer specifications. (Refer to the figure below.)
Example) When the number of lines is set to 70, and the first line and 70th line are unprintable
The printable
area of
the printer
Some specified areas
are not printed.
Because areas are
unprintable, both lines
are not printed.
1
2
3
3
68
69
70
The printable
area of
the printer
Upper margin
Number of lines
Bottom margin
By the GOT (Report function),
adjust margins and the number
of lines so that the specified
area is within the printable area.
1
2
66
67
68
When some of lines are not printed for the report function of the GOT, configure the printer setting with no
trimming. Doing so may print the lines correctly.
(3) Paper jam
For the paper jam, remove the paper, and then execute the printing process again by using the GOT.
When the printing process does not start after the above actions, execute any of the following methods.
(a) Press the cancel button on the printer to stop the printing process, and then execute the printing process
again by using the GOT.
(b) Disconnect and connect the cable of the printer, and then turn on the printer again. (The printing process
starts again automatically.)
(d) Press the OK button on the printer to stop the printing process. Then execute the printing process again by
using the GOT.
(e) Press the cancel button on the printer. (The printing process starts again automatically.)