Specifications

12.2.3. Checking Synchronization with the Access Point
When performing data communication with a wireless communication device, use the
BHT_RF_Synchronize function to check whether synchronization with the access point has been
obtained.
The following is a list of possible reasons why it may not be possible to obtain synchronization with the
access point.
(1) The wireless communication device is currently open.
Several seconds are required to obtain synchronization with the access point after opening the
wireless communication device.
Furthermore, when using DHCP, there are times when several tens of seconds are required to
obtain the IP after connecting to the network.
(2) When the wireless device is moved from the current access point to the next access point during
roaming
(3) When the wireless device is moved outside the radio-wave area covered by the access point.
(4) When the wireless device is moved to a location where an obstruction prevents wireless
communication with the access point.
37