User's Manual
Table Of Contents
- About This Manual
- Liability Limitations
- Customer Registration
- Usage Precautions
- SAFETY PRECAUTIONS
- Wireless Equipment
- Components and Functions
- Input Method
- Proper Care of the BHT
- Preparation
- Step 1 Charging
- Step 2 Turning ON the Power
- Scanning codes
- Battery Power Level Indicator
- Replacing the Batteries
- Using the BHT after Long Non-Use
- Troubleshooting Guide
- Turning ON/OFF the Backlight
- Resetting and Full Resetting
FCC Regulation (for United States America)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note:
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
<Information>
Company Name : DENSO PRODUCTS AND SERVICES AMERICAS, INC.
Address : 3900 Via Oro Avenue, Long Beach, California 90810, U.S.A.
Tel : +1-310-834-6352
IC Regulation (for Canada)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
2.4 GHz WLAN
For product available in the USA/Canada market, only channel 1-11 can be operated. Selection of
other channels is not possible.