User's Manual
Table Of Contents
- About This Manual
- Liability Limitations
- Customer Registration
- Usage Precautions
- SAFETY PRECAUTIONS
- Wireless Equipment
- Components and Functions
- Input Method
- Proper Care of the BHT
- Preparation
- Step 1 Charging
- Step 2 Attaching stylus
- Step 3 Turning ON the Power
- Scanning codes
- Battery Power Level Indicator
- How to Replace the Battery
- Using the BHT after Long Non-Use
- Troubleshooting Guide
- Turning ON/OFF the Backlight
- Resetting and Full Resetting
- Battery Recycling Request
- Recycle Regulation（for Turkey）
Step 1 Charging
The battery is not charged when purchased and must therefore be charged prior to use.
The following Cradle can be used with the BHT.
Cradle: CU-1211, CU-1233
The charge time is approximately 3 hours (standard rechargeable battery) or 4.5 hours
(large-capacity rechargeable battery).
• An almost completely discharged battery should take this time to become fully charged.
■Charging with the BHT
Place the BHT on the Cradle.*
The LED illuminates in red and charging begins.
The BHT Indicator LED will change to green when
charging is complete.
Indicator LED
Cradle
* Refer to “Ho
w to Replace the Battery” for how to insert the battery into the BHT main body.
Remove the battery from the BHT main body or the Cradle and store at cool and dry place, when you don’t
use your BHT for an extended period of time.
Check the condition of battery on the following points before you store it for a long time:
- If the battery is full charged (a state right after charge is completed), and
- If the remaining battery level is very low (there is not enough power left to activate the BHT).
Long-term storage under these conditions may deteriorate the performance and life of the battery. You are
recommended to ensure that the battery is at least at the
charge level required for long-term storage
In addition, even you don’t use the battery for a long term, keep this power level by recharging once a year
in order to maintain the battery performance.