User`s manual

Quick start
If you are an advanced user, you can set up your Wi-Drive following these 6
steps:
1. Power up Wi-Drive with the 3G modem connected to the lower connector of
the double USB port
2. Connect to the WiFi network “Dension Wi-Drive”
3. Go to the administration page at the address “www.wi-drive”
4. Enter the default administration password: “admin”
5. Set up your internet and WiFi preferences
6. Save the settings and reconnect to the WiDrive
1 Setup
Once Wi-Drive is installed in your car, you can begin with setting up its internet
connection settings and adjust WiFi parameters.
You will need to be in the WiFi range of Wi-Drive and it needs to be powered on
(the MOD light should flash slowly in green colour).
1. Using the WiFi connection
manager of your computer,
connect to the WiFi network
“Dension Wi-Drive”