Dension Wi-Drive Dension Wi-Drive creates a WiFi hotspot using the internet connection of a 3G USB modem. Dension Wi-Drive User's Manual v1.
Quick start If you are an advanced user, you can set up your Wi-Drive following these 6 steps: 1. Power up Wi-Drive with the 3G modem connected to the lower connector of the double USB port 2. Connect to the WiFi network “Dension Wi-Drive” 3. Go to the administration page at the address “www.wi-drive” 4. Enter the default administration password: “admin” 5. Set up your internet and WiFi preferences 6.
2. Open a web browser (e.g. Internet Explorer) on your computer and enter the address “www.widrive” to get to the administration page of the device. Enter the default administration password “admin” and click the Login button. 3. You are now on the settings page of your Wi-Drive, where you can set up your internet connection and WiFi preferences. Please consult the description of each setting in the table below, and set them accordingly. After you are finished, click the Save button.
1.1 Settings Section Setting Description GSM Preferences PIN code If the SIM card inserted in your 3G modem requires a PIN code, enter it here Country Select the country where your mobile network operator is in Provider Select your provider from the list, and if available also your data subscription plan (e.g. pre-paid, contract, etc.
• WPA2 Pre-Shared key: Clients will be required to enter the passphrase (password) that you set up Passphrase The password used to connect to Wi-Drive in WPA2 mode. Web Interface Preferences Password, Confirm password The password for the administration page you are at. With this, you can prevent users from changing your settings. 1.2 “About” page The “About” tab on the administration web page contains information about your Wi-Drive device, like its serial number and software version.
2.2 Push button The push button on the front left side of the device allows two advanced functions: Length Function Two short presses System reset Very long press (>15 secs) Usage Use this function if Wi-Drive becomes unresponsive in any state Restore factory defaults If you forgot the administration password, or you want to restart configuration from the default settings. 3 Operation If your Wi-Drive is installed and fully set up, it will power up when the ignition of the car is on.
• page) Try to connect to the internet with your 3G modem on a computer to see if it works 5 Firmware Upgrade The operating system of Wi-Drive (firmware) can be upgraded via connecting a USB disk to one of the USB ports. For detailed instructions, consult the Release Notes that came with your firmware upgrade package. 6 Default settings WiFi network name (SSID) “Dension Wi-Drive” (open network) Administration page www.widrive (192.168.100.
Installation 8.1 Wi-Drive connectors WiFi antenna port Power connector Push button Status LED USB port for 3G modem All non-described ports, connectors and switches are not used, and should remain unconnected. Wi-Drive can be installed in two ways: 8.2 Plug & Play For a plug and play connection follow these steps: 1. 2. 3. 4.
8.3 Fixed installation If you want to have a fixed installation, with Wi-Drive possibly hidden, follow these steps: 1. Connect the wire power wire harness to the cars electrical system. The red wire needs to be connected to constant +12V with a supply of 1 Amps at least. 2. Connect the USB 3G modem to the lower connector of the double USB port 3. Connect the power wire harness connector to Wi-Drive 4.
