Installation manual

Wi-Drive Installation Manual

position recommended for the main Wi-Fi antenna: the front middle center of the dashboard.

Use standard USB extension cable if necessary.

The 3G Internet access may work in other locations as well (as your phone does anyway),

but optimum location reduces Internet dropouts, and maximises the quality of service.

In case of metallic windscreens you face the same problem, as you want to make phone

calls from the cabin. The options you have:

o Use the factory installed phone kit (if you have) to access the Internet, and share the

connection with Wi-Drive via Bluetooth.

o Install a 3G modem externally, i.e. in the housing of the side mirror.

For configuring the 3G USB modem (dongle) please follow these steps:

PLEASE MAKE SURE YOUR 3G MODEM IS NOT CONNECTED YET TO WI-DRIVE!

Wi-Drive may contain a configuration not suitable for your 3G service provider and modem. In

order to prevent SIM lockup situations, if Wi-Drive detects a wrongly given PIN code, it will be

disabled. The user must set the correct PIN code using the web interface.

1. Power on Wi-Drive by turning on the ignition (permanent power or Accu-Pack

installation) or by starting the engine (continuous cigarette lighter installation). The Wi-

Drive “Status LED” should turn on Orange for a few seconds (boot up), than blink

green slowly – to indicate Access Point (AP) mode.

2. With a notebook you should be able to see the factory default Wi-Drive Access Point

and connect to it.

SSID: dension-widrive

Passkey: 12345678

3. Start your Internet browser (Internet Explorer, Firefox, etc.) and go to this address:

http://192.168.10.1

You have to be connected to Wi-Drive web interface.

4. Sign in with the default password: “password”. You can change this password later on

the web interface.

5. Once successfully signed in, you will see several tabs with the configuration details.

Please click on the “3G Internet” tab.

6. If you have a factory defined entry please delete it first by clicking the “Delete” button.

7. Click on “Choose from presets or add new” drop down list and according to your

country and service provider locate and select the entry we pre-defined in Wi-Drive. If

you do not find the entry you need you will have to set the parameters manually.

8. After selecting from the list (or manual entry), the Name, APN, Username, Password,

DNS1, DNS2, Gateway fields are filled.

9. Click on Add next to the list. Now you will have a line with the settings under the

parameters and click the Active button at the beginning of the entry.

10. In the “Authentication code” entry type your modem’s PIN number or leave it blank if

your modem does not use one.