Installation manual

Wi-Drive Installation Manual

22. In the “Authentication code” entry type your Bluetooth PIN number for pairing.

23. Click Apply below this entry.

24. Restart Wi-Drive (use the Service tab).

25. After about 30 seconds Wi-Drive will try to connect to your phone (with a name “wid”).

If it is not yet paired, pair it now with the PIN you entered. Your internet connection will

be up and available for use through Wi-Drive’s Access Point.

For configuring the 3G phone access via Bluetooth PAN please follow these steps:

Not released yet, will be supported later.

5 Wireless Download Application Setup and Configuration

After a successful physical installation of Wi-Drive you have to set up the whole system,

including your home computer or your notebook.

Advanced users may use their notebooks, connect directly to Wi-Drive, and make all

settings directly on it’s web-interface.

Factory default Wi-Drive setting provides the following Access Point (AP):

SSID: dension-widrive

KEY: 12345678

WEB-interface: http://192.168.10.1

Follow these steps:

1. Turn on Wi-Drive by switching on the ignition (or by starting the engine), or just simply

pressing the Push button on a sleeping Wi-Drive for 2 seconds.

2. Launch the browser on your computer and go to Wi-Drives web interface address.

3. On the login screen use: “password” as the default password.

Please change factory settings, otherwise others may access to your system.

Standard setup steps:

1. Make sure that Wi-Drive is in sleep mode (see Push button operation in chapter 7)

and the car radio is switched-off.

2. Insert a USB pen drive to the “USB Storage” slot (single) of Wi-Drive.

Turn on Wi-Drive by switching on the ignition (or by starting the engine), or just simply

pressing the Push button on Wi-Drive. Wi-Drive will write a configuration file to the

pendrive. It is important, that your head unit is switched off.

You will see a short blinking of the LED on the pen-drive (if it has), while Wi-Drive is

writing. This takes a few seconds only (wait 30 seconds), than remove the pen-drive

and take it to you computer.