Installation manual

Wi-Drive Installation Manual

1. Power on Wi-Drive by turning on the ignition (permanent power or Accu-Pack

installation) or by starting the engine (continuous cigarette lighter installation). The Wi-

Drive “Status LED” should turn on Orange for a few seconds (boot up), than blink

green slowly – to indicate Access Point (AP) mode.

2. With a notebook you should be able to see the factory default Wi-Drive Access Point

and connect to it.

SSID: dension-widrive

Passkey: 12345678

3. Start your Internet browser (Internet Explorer, Firefox, etc.) and go to this address:

http://192.168.10.1

You have to be connected to Wi-Drive web interface.

4. Sign in with the default password: “password”. You can change this password later on

the web interface.

5. Upon successful sign in you will see several tabs with the configuration details.

Please click on the “3G Internet” tab.

6. If you have a factory defined entry please delete it first by clicking the “Delete” button.

7. Click on “Choose from presets or add new” drop down list and according to your

country and service provider locate and select the entry we pre-defined in Wi-Drive. If

you do not find the entry you need you will have to set the parameters manually.

8. After selecting from the list (or manual entry), the Name, APN, Username, Password,

DNS1, DNS2, Gateway fields are filled.

9. Click on Add next to the list. Now you will have a line with the settings under the

parameters and click the Active button at the beginning of the entry.

10. In the “Authentication code” entry type your modem’s PIN number or leave it blank if

your modem does not use one.

11. Set On demand: check this if you want Wi-Drive to connect when a device needs

Internet connection and disconnect on network inactivity.

12. Set Roaming: check this if you allow Internet access when roaming.

13. Set Limit: leave this 0 (not used yet).

14. Click Apply under Limit.

15. Click on the “Bluetooth” tab.

16. If you have a factory defined entry please delete it first by clicking the “Delete” button.

17. Connect your USB Bluetooth dongle to one of the USB extension ports.

18. Enable Bluetooth connection on your phone; make sure the phone is “visible to other

devices”. Consult your phone's user manual for instructions.

19. Click on the Bluetooth tab again, and wait while the page is loaded (“Loading, please

wait…”). Wi-Drive now scans for nearby (visible) Bluetooth devices; this might take

about 10 seconds. If the Phone list is shown immediately then click on the Bluetooth

tab again until you have the “Loading, please wait…” message up for several

seconds.

20. After a successful scan the “found” Bluetooth devices are listed in the dropdown list

(“Choose one or add new…”). Select the Phone you want to use for Internet

connection and click Add.

21. Click Apply below the Phone list.