Installation guide

Mounting the ice>Link: Plus cradle
Assemble the base of the iPod cradle with an optional vehicle specific adapter.
Optional adapter is not required, however recommended for easy and damage free installation.
Attach the cradle to the back with at least 2 screws. If holes do not align rotate the base until a match is found.
Insert the front of the cradle to the back piece, but do not force the cradle onto the base. The pin is keyed and
will only insert in one orientation. Align cradle orientation as desired. Tighten the set screw with the included
Allen wrench. Do not drive the set screw through the pin, only tighten the screw so it grabs the pin.
Once set, the cradle should not be forced to a different position. To adjust, first loosen the set screw, tilt and
rotate to realign, and then fasten the screw again.
A variety of spacers and rubber pads are included to provide the best support for the iPod. These are held in
place by a double sided tape, and may be removed by the end user if a thicker iPod is used later on.
!
NEVER install any object in the way of airbags! The force of an opening airbag can launch any
object in it’s path with sufficient force to kill someone!