User`s manual

10 Error Codes
two-digit code
p to solve it.
he first digit of e error category, the second digit refers to the problem source:
Error
The D signals unexpected events during operation with an error message. The
appearing beside the message refers to the cause of the problem, and may also hel
T the code refers to th
0x Communication
01, 02, 03, 04, 0 5, Communication error
06
1x Hardware Error
10, 11 PROM fault Internal I2C bus error. EE
18, 19 Internal I2C bus error. DSP fault
2x HDD Error
20, 21 HDD didn’t respond within timeout Check Jum
o
pers, connectors, try
ther HDD
22 Drive fault
23 Not ATA compatible HDD
24 The HDD doesn’t support LBA address HDD ing mode Try other
26 HDD not detected
25, 27, 28, 29, 2A Drive fault
3x File System Error
30 Unknown file system (not FAT32) Create FAT 32 partition
31, 32 Wrong FAT entry Run Scandisk
33 Broken file cluster chain Run Scandisk
35 Wrong long filename entry Run Scandisk
34, 36, 37, 38, 3 oftware error 9, Unknown s
3C
3A Invalid path name
3B eration Invalid op
3D Invalid operation
4x Data Read Error
40 Data read error from HDD HDD may have bad sectors, run
Scandisk with full test options
5x File Not Found
50 File Not Found
51, 52, 53 Unknown software error
6x File Format Error
60 Invalid DMP3 system file header
61 Checksum error, file damaged
62 Wrong system file version
63 File format error
64 Wrong file length
65 ber Wrong file serial num
7x Disk/SmartMedia Full
70 HDD is full
71 FAT16 root directory full
72 Formatting error
8x Unknown Error
80, 81, 82, 85, 86 Unknown software error
83 SW upgrade list is too long Cluster size is less than 2K.
Impossible to upgrade the
Firmware
84 Firmware integrity error Upgrade firmware again
9x User Cancel
90 Operation cancelled by the user
29
MAN_DH100ix_0200_EN