Owner`s manual

19
Setting the network [Network]
5
If there is an encryption setting for the access point
you selected in step 4, enter same encryption key as
used for the access point. (If there is no encryption
setting, proceed to step 6.)
Use uio p or 0 – 9, +10 to input the “Password” (encryption
key) and press ENTER or p. Enter the same encryption key as
used for the access point.
•The types of characters that can be input are as shown below.
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
GUpper case charactersH
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH ! “ # $ % & ‘ ( ) z + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜
GNumbersH
0123456789 (Space)
•When no security settings have been used in the Internet
connection settings, this step is not necessary.
6
Use i to select “Test Connection”, then press ENTER
or p.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the network.
•This unit performs automatic network setup due to the DHCP
function.
n WPS Settings (Push-button method)
By just pressing the WPS button on your router and this unit, the
wireless LAN connection settings are made.
•Before turning this unit on, make sure that an Ethernet cable is
not connected to this unit. If a cable is connected, have this unit
enter the power standby mode and disconnect the cable.
•After the unit is turned on, it takes approximately 30 seconds for
the WPS button on this unit to be available.
1
Press the WPS button of the router.
2
Press WPS on the rear panel.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the LAN.
•When the connection is made successfully, “Connected!” appears.
•If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 2 again.
NOTE
If the router uses WEP, WPA-TKIP or WPA2-TKIP encryption,
connection is not possible using the WPS button. In this case, connect
using “Auto-scan” or “Manual”.
n WPS Settings (PIN code method)
1
Press SETUP.
Turns on the Menu settings mode
and the Menu appears on the display
(vpage11 “Menu map”).
ADD
CALL
FAVORITE
SEARCH
. / ABC
a
/
A
DEF
GHI JKL
MNO
PQRS TUV WXYZ
*
1 2 3
4 5 6
7 8 9
+10 0
RC-1174
CH
- +
CH
TUNE +TUNE
-
ANALOG IN
TUNER DIGITAL IN
POWER
CLOCK DIMMERSLEEP
MUSIC
SERVER
INTERNET
RADIO
ONLINE
MUSIC
VOLUME
SDB
TONE
MUTE
TOP MENU INFO
MODE
CLEAR
USB
iPod CD
RANDOM
REPEAT PROGRAM
SETUP
ENTER
2
Use ui and ENTER to select
“Network” – “Settings” – “WPS
(Wi-Fi Protected Setup)” – “PIN
code”, then press ENTER or p.
The access point that you have set is
displayed.
3
Use ui to select the access point
whose PIN code you want to
display, and press ENTER or p.
PIN code number is displayed.
4
Set this PIN code to the register.
When connection is established with access point,
“Connected!” is displayed.
Preparations
Operations
Information
Preparations