Super Audio CD Receiver Owner's Manual


ENGLISH
Getting Started Connections Setup Playback Setting the Timer Other Functions Troubleshooting Specifi cations
1
Press [PURE DIRECT/TONE] and select the mode you
want to adjust.
BASS
TREBLE
Pure D
(PURE DIRECT)
BALANCE
2
Adjust the volume with [4/o, 6/p].
b Thereafter, to adjust another mode, press [PURE DIRECT/TONE].
b If no operation is performed for 3 seconds, the adjustment is
retained and the normal display reappears.
Adjusting the Tone
[Selectable modes]
Pure D
(PURE
DIRECT)
: This is the mode that recreates the original sound most
faithfully, providing extremely high quality sound.
[Selectable items]
on off
BASS
: Adjusts the bass sound.
[Variable range]
–8dB
~
+8dB
TREBLE
: Adjusts the treble sound.
[Variable range]
–8dB
~
+8dB
BALANCE
: Adjusts the left/right volume balance.
[Variable range]
+L10
~
CENTER
~
+R10
Press [4/o] when you want to adjust the left channel,
and [6/p] when you want to adjust the right channel.
Settings made upon purchase:
• Pure D (PURE DIRECT) ·············off
• BASS ·······································0dB
• TREBLE ···································0dB
• BALANCE ························ CENTER
When “Pure D” is set to “on”, digital output is switched off. What is
shown on the display also goes off. (When not playing or when no disc
is loaded, only part of the display is shown.)
NOTE
• When “Pure D” is set to “on”, you cannot set “BASS”, “TREBLE” or
“BALANCE”.
• When “Pure D” is set to “on”, you cannot use [DIMMER].
Switching the Brightness of the Display
Press [DIMMER].
100% 40%
OFF
b The display’s brightness switches each time the button is
pressed.
Turning the Sound Off Temporarily
(Muting)
Press [MUTE].
The “Mute on” is displayed.
To cancel, press [MUTE] again.
(The mute mode is also canceled when the <VOLUME> is turned or a
[VOLUME df] is pressed.)
Playback
[VOLUME df]
[PURE DIRECT/
TONE]
[MUTE]
[DIMMER]
[4/o]
[6/p]
1/3
[2]
[TU–/6,TU+/7]
[CH–/8, CH+/9]
[NUMBER]
[REPEAT/RANDOM]
[TIME/DISPLAY]
< 2 / 5 > 1 / 3
<VOLUME>
<SOURCE>
< 8 /–, +/ 9 >
Button located on both the main unit and the remote control
unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
1.RCD-CX1E3_ENG.indd 13 2008/06/30 11:12:40