Owner`s manual
ENGLISH
Troubleshooting
Specifications
-
...
'
:.c.
1.
If a problem should arise, first check
the
following:
2.
Is
the set being operated
as
described in
the
operating instructions?
If
this unit does not operate properly, check the items listed
in
the table below. Should the problem persist, there may
be
a
malfunction.
In
this
case,
disconnect the power immediately
and
contact your store of purchase.
Frequency:
Batteries:
Battery service life:
LR03/AAA
Type
(four batteries)
Approx. 3 months
(depending
on
usage frequency)
2,405 MHz - 2,475 MHz
(15
chI
Bandwidth 2 MHz
Radio frequencies: 2.4
GHz
Modulation method:
O-OPSK
Spectrum spread system:
DSSS
Communication distance:
30
m (varies with the environment)
Maximum
external dimensions:
63
(W)
x 233
(H)
x
28
(D)
mm
(2-31/64" x 9-11/64" x 1-7/64")
Weight:
170
g (Approx 6.0
oz)
2
2
2
1
2
6
22
23
Page
• Insert the batteries
in
the proper direction,
following the polarity marks
in
the battery
compartment.
• Move the set to a place
in
which the
remote control sensor will not
be
exposed
to strong light.
• Adjust the screen's brightness at
"Adjusting the contrast':
Countermeasure
• Remove the obstacle.
• Replace with
new
batteries.
• Operate within the specified range.
• Move away from microwave ovens,
devices using a wireless LAN, or other
wireless devices.
• Use the procedure below to set the
network again.
CD
Press the
RESET/CON
FIG
button for
about
10
seconds so the indicator lights
red.
CV
Press the RESET/CONFIG button
again
for about 3 seconds
so
the indicator
lights green.
Q)
Next register the RC-7000CI (sold
separately) again.
Cause
• Batteries
are
worn.
•
You
are
operating outside of the specified
range.
• Obstacle between main unit
and
remote
control unit.
•
The
batteries
are
not inserted
in
the proper
direction,
as
indicated
by
the polarity
marks
in
the battery compartment.
•
The
set's remote control sensor
is
exposed to strong light (direct sunlight,
inverter type fluorescent bulb light, etc.).
• Brightness setting
is
inappropriate.
•
Radio
interference with other devices.
• Change
in
wireless environment.
Symptom
Set does not work
properly when remote
control unit operated.
Display screen does
not
appear.
Wireless connections
with the
RC-
7001
RCI
(sold
separately) cannot
be
established.
27