Owner`s manual


Getting Started Connections Setup
Troubleshooting
ENGLISH
Specifications
G
Example: 3
H
Warning and Protection Data Screen
G
Example: 4
H
Audio Signal and Trigger Input Screen
G
Example: 5
H
Option Setup Screen
5
Operate.
G
Example: 1
H
Channel Setup Screen
z
:
Normally, there is a change to the latest information each time
you operate. When operated from the main unit, click because the
screen is not updated.
G
Example: 2
H
System Setup Screen
Click on the tab you want to set, and
select from the displayed items.
Enter figures or click “< ” or “>” to make
the setting, and then click “Set”.
NOTE
• To perform web control, you must connect a web control device
such as a PC to the same network as the POA-3012CI.
• With web control, some network settings, etc., cannot be set.
• When updating firmware, settings made by the web controller may
be reset.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
reset to their default values.
1
Unplug the power cord from the power outlet.
2
Connect the power cord to the power outlet while
simultaneously pressing the ZONE 5 and DISPLAY
buttons.
3
When all Zone operation mode indicators are
illuminated in red and “ zEEPROM INIT.z” is
displayed, release nger from two buttons.
If in step 3 the could not be start over from step 1.
To use the web control function, set the menu “Main Setup”– “POWER
CONFIGURATION” – “ON LINE” (vpage 14).
Operation
Click “v” and select
from the displayed
items.
Click when you update to
the latest information (z)
Displays Warning and
Protection Data.
Displays On/Off of
Audio signal and
Trigger In.
No setting item.
Click “S” for the item
you want to set.
Click when Firmware
Update starts.
1.POA-3012CI_ENG.indd 21 2008/04/08 9:25:52