Operation Manual

4
Before use
Part names and
functions
Connections
Basic
operations
Installing and setting up
supplied software
USB settings
Troubleshooting Index
Specifications
Signal system chart
Connections
Connecting to a computer
Use the supplied USB cable to connect the unit with a computer so
that USB MIDI and USB AUDIO signals can be sent and received.
n Compatible computers
•Computers running the following computer OS versions can be
connected to this unit.
•Mac OS X 10.6 or later
•Windows XP SP3 or later (32 Bit only)
•WindowsVistaSP2orlater(32or64Bit)
•Windows 7 (32 or 64 Bit)
Computers running other OS versions may not be compatible
with the USB MIDI. For this reason, such computers may function
abnormally after connecting by USB to this unit.
•Mac, Mac OS is a registered trademark or trademark of Apple Inc.
intheUnitedStatesand/orothercountries.
•Windows is a registered trademark or trademark of Microsoft
CorporationintheUnitedStatesand/orothercountries.
.
n Automatic driver installation
When you connect the unit to a computer, drivers for the unit are
automatically installed in the computer.
When this unit is connected to a Windows computer, the following
message is shown at the bottom right of the screen.
Total Track Control
Found New Hardware
USB AUDIO Device
Onceinstallationiscompleted,a message “Your new hardware
is installed and ready to use.” appears as shown, and you can
operate the unit.
Your new hardware is installed and ready to use.
Found New Hardware
•For Mac OS, the unit can be used immediately after connecting.
Insert the supplied AC adapter DC plug into the DC IN jack of the unit
and then insert the power plug to the outlet.
NOTE
Insert the plug fully and securely into the socket. Incomplete
connection to the power supply may cause damage to the unit, or
noise.
To AC outlet
(AC120V,60Hz)
AC adapter (supplied)
DC plug
AC adapter
cable holder
To AC outlet
(AC230V,50Hz)
U.S.A and Canada models
European,U.KandAsia/
Pacific models
To prevent the DC plug from disconnecting, it is recommended that
you should anchor the power cord to the AC adapter cable holder. Use
a Phillips screwdriver to secure it.
Connecting the power cord