Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Introduction
- System Requirements
- File / Format Compatibility
- Supplied Accessories
- Parts & Controls
- Placing your HEOS AVR
- Setup
- Operation
- Using your HEOS AVR
- HEOS Account
- Selecting a Room / Device
- Listening to the Same Music in Multiple Rooms
- Selecting the Music Track or Station from Music Sources
- Rearranging the Now Playing Queue
- Deleting Songs from the Play Queue
- Deleting All Songs from the Play Queue
- Saving Playlists
- Quick Select Function
- Watching TV
- Watching Other Device
- Listening to Radio
- Playing Music Stored On Your Mobile Device
- Playing Music from Your Networked PC or NAS
- Streaming an External Audio Device to Any HEOS Device
- Playing Music from a USB Device
- Playing Music from Bluetooth Device
- Playing from Streaming Music Services
- Managing Inputs
- Managing Your Phone
- Using the Favorites
- Making Adjustments
- Updating Your System
- Advanced Features
- Power Management
- Using your HEOS AVR
- Updating your System
- Troubleshooting
- Specs
- Quick Start Guide
- Spec Sheet
- Speaker Wire Labels
- Spotify
- Warranty
I hear distortion when using the AUX input
Solution Refer to Page
0
The analog output signals from some sources can be fairly strong. If the input level of the source device is turned up high, it
could overload the inputs of the HEOS device. This is unlikely to cause damage, but can cause distorted sound. Initially, set the
volume of the source to a medium – low level, then turn it up as needed. If you hear distortion, turn down the device’s volume
control.
－
Connecting to a WPS network
Solution Refer to Page
0
If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless device can optionally connect to your
network using the “Push Button” method by following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the Connect button on the rear panel of the HEOS device for 3 seconds.
3. The LED on the front of the device will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the device will turn solid blue.
6
Contents Setup Use Troubleshooting Status LED Appendix
61