Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Introduction
- System Requirements
- File / Format Compatibility
- Supplied Accessories
- Parts & Controls
- Placing your HEOS AVR
- Setup
- Operation
- Using your HEOS AVR
- HEOS Account
- Selecting a Room / Device
- Listening to the Same Music in Multiple Rooms
- Selecting the Music Track or Station from Music Sources
- Rearranging the Now Playing Queue
- Deleting Songs from the Play Queue
- Deleting All Songs from the Play Queue
- Saving Playlists
- Quick Select Function
- Watching TV
- Watching Other Device
- Listening to Radio
- Playing Music Stored On Your Mobile Device
- Playing Music from Your Networked PC or NAS
- Streaming an External Audio Device to Any HEOS Device
- Playing Music from a USB Device
- Playing Music from Bluetooth Device
- Playing from Streaming Music Services
- Managing Inputs
- Managing Your Phone
- Using the Favorites
- Making Adjustments
- Updating Your System
- Advanced Features
- Power Management
- Using your HEOS AVR
- Updating your System
- Troubleshooting
- Specs
- Quick Start Guide
- Spec Sheet
- Speaker Wire Labels
- Spotify
- Warranty
Connecting speakers
Carefully check the left (L) and right (R) channels and + (red) and – (black)
polarities on the speakers being connected to this unit, and be sure to
connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
.
2
Turn the speaker terminal counterclockwise to loosen
it.
.
3
Insert the speaker cable’s core wire to the hilt into the
speaker terminal.
.
4
Turn the speaker terminal clockwise to tighten it.
.
NOTE
0
Disconnect this unit’s power plug from the power outlet before connecting the
speakers. Also, turn off any connected powered subwoofers.
0
Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other.
0
Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0
Use speakers with an impedance of 4 – 16 Ω/ohms. The protection circuit may be
activated if speakers with an impedance other than specified are used.
.
FR FL C SR SL
Subwoofer
with built-in
amplifier
Contents
Setup Use Troubleshooting Status LED Appendix
14