User Guide

Caution: When the firmware update starts correctly, the GUI and the audio
signal, etc. everything stops, and becomes the update operation.
14) When updating starts, the power indicator lights red.
15) The GUI display disappears, and becomes only the FL display.
16) During update, a rough remaining time is indicated on the display. When
updating is complete the power indicator lights green and normal status is
resumed.
17) During the updating, the FL Display indicates the procedure of update the
firmware. Time necessary for update: approximately 30 min.
Caution: The update time might change depending on the situation of the DPMS
server and the speed of the Internet environment of the customer house.
18) The unit initializes automatically.
Confirmation of the version:
1) Press the "OPEN/CLOSE" button and open the Disc Tray.
2) Remove the Disc from the Tray.
3) Please confirm! "NO DISC" on the FL Display.
4) While pushing the "PLAY" and "OPEN/CLOSE" button, turn on the power of
unit.
5) Plug in AC CORD.
6) The indication of "PLAY" and "PAUSE" will be displayed on FL Display.
7) Please confirm! "NO DISC" on the FL Display, and wait 10 seconds.
8) Press the buttons on the remote control in the order of "3", "2", "6" and "5".
9) The version of the firmware will be indicated on the FL Display.
10) The firmware list will also be shown on connected TV (GUI).
11) Push the "UP" button of cursor button, version of the each firmware will be
indicated on the FL Display.
Cautions during the rewriting operation:
1) Please do not turn off the Power of the unit during the rewriting operation.
2) If the Display isn’t turning into the following version of the firmware during the
rewriting operation, wait longer than 10 minutes after closing the Disc Tray.
Then, turn off the Power of the unit and start the rewriting operation from the
beginning again.
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.