DIRECT DRIVE MANUAL TURNTABLE SYSTEM DP-500M OPERATING INSTRUCTIONS SERIAL NO.
IMPORTANT TO SAFETY CAUTION WARNING: RISK OF ELECTRIC SHOCK DO NOT OPEN TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: CAUTION: 1. 2. 3. Handle the power supply cord carefully. Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord.
Thank you very much for purchasing the DENON direct drive manual turntable system. Please read the operating instructions thoroughly in order to acquaint yourself with the turntable system and achieve maximum satisfaction from it. TABLE OF CONTENTS FEATURES ......................................................................3 1. PART NAMES AND FUNCTIONS ..............................3 2. ASSEMBLY.................................................................4 3. ADJUSTMENTS ............................
2. ASSEMBLY • Do not plug in the power cord until assembly is completed. (1) Mounting the turntable (3) Mounting the cartridge Turntable sheet • The cartridge is not included. 1 Mount your cartridge on the head shell. Turntable • The head shell's lead wires are color-coded. Use tweezers or the like to securely connect the lead wires to the corresponding terminals on the cartridge, referring to the indications on the cartridge or the cartridge’s instructions. Red ..........................
3. ADJUSTMENTS • Turn the power off when performing adjustments. (1) Insulator feet height adjustment 1 The height of each foot can be adjusted by rotating in by hand. • Place the turntable where you intend to use it and adjust the height of each insulator foot so that the turntable mat surface becomes level. Insulator feet (2) Stylus pressure and anti-skating adjustment 1 Set the anti-skating knob to "0". 5 Hold 0 3 .5 .5 0 3.0 1.0 1 .5 .
4. CONNECTIONS • Be sure to turn off the amplifier's power when making connections. 1 Use the included connecting cords to connect the left(L) and right(R) output terminal (PHONO OUT) to the amplifier's PHONO L and R input terminals. R L OUTPUT R L 2 Connect the ground wire (with the output cords) to the amplifier's GND (ground) terminal. Amplifier R L 3 Plug the power cord into an AC120V power outlet.
6. TROUBLESHOOTING Make sure of the followings before you consider as any malfunctions : 1. Are all the connections correct? 2. Is the set being operated correctly in accordance with the operating instructions. 3. Are the speakers and amplifiers functioning correctly? If the turntable system still does not function properly, check it again, using the check list below. If the symptom does not correspond to the check list, please contact your DENON dealer.
www.denon.com Denon Brand Company, D&M Holdings Inc.
