User Guide
4
CARTRIDGE REPLACEMENT
(The cartridge forms a single body with the head shell. Use the following procedure to replace it.)
1. Remove the screw on the bottom of the head
shell sa shown in the diagram.
2. Rotate the entire head shell gently in both direc-
tions.
The neck of the head shell is attached to the pipe
arm.
Turn it gently until the shell comes loose.
3. Carefully remove the head shell.
(Be careful not to break the lead wire.)
4. Remove the tip of the lead wire from the car-
ridge terminal.
5. Install the new cartridge (with head shell).
The polarities are as shown on the diagram.
6. Assemble by following the removal procedure
in reverse order.
Use one drop of Cemedyne #3000 to atttach the
neck of the head shell and the pipe arm.
Screw (philips) small
Desk, table, etc
Screwdriver
(philips) small
Top
L
H
(white)
R
H
(Red)
R
E
ground wire (red side)
Tip side (as seen from the rear of the cartridge)
L
E
ground wire (white side)