User Guide

9
5. When the check is complete, one of the following results will appear:
• Good: The checked media is suitable for use.
• Good w/o Rec Mon: The checked media is suitable for simple recording, but is
unsuitable for record monitoring.
• Poor: The checked media is unsuitable for use.
6. Select OK to end the test.
Recording
1. Press the Record button. The unit will switch to a record paused state and the Record
button will flash.
2. Use the jog dial to adjust the recording level. Hold the Shift button and use the jog dial to
adjust the recording balance.
3. Press the Record button to begin recording.
The file name of the recording includes the UPnP (Universal Plug and Play) device name, the
recording start time, and user area data.
The file creation formats can be selected in System Setting > File Name Form. The file
name can be inputted when System Setting > User Area is On. After recording has started,
the recording start time in the file name continues to proceed until the recording start time is
confirmed.
4. Press Stop to turn off recording.
Default Settings
The main default settings for DN-900R are as shown below.
Preset Setting
One Touch Record Off
Audio Input Bal
Record Format MP3-320
Record Channel Stereo
Sample Rate 44.1k
Silent Skip Off
Play Range Folder
Play Mode Continuous
System Setting
Record Folder Current
Signal Pass Through On
Output Rate Auto
Line/Mic Lch Line
Line/Mic Rch Line
Serial Bit Rate 9600