User Guide

26
DHT-500SD
TC2001(AMP:IC52,62,72)
REF
VNNSENSE
VPPSENSE
AGND
OAOUT1
MUTE
BBM1
BBM0
OAOUT2
INV2
FBKGND2
OCD2
Y2
Y2B
Y1B
Y1
HMUTE
FBKOUT1
FBKGND1
VPWR
FBKOUT2
DCMP
1
15
14
13
11
10
12
9
8
7
6
5
4
3
2
16
17
18
BIASCAP
INV1
V5
OVRLDB
OCD1
NC
21
20
19
22
23
24
25
26
27
28
TC2001 Audio Signal Processor Pin Descriptions
Pin Function Description
1 BIASCAP Bandgap reference times two (typically 2.5VDC). Used to set the
common mode voltage for the input op amps. This pin is not capable of
driving external circuitry.
2, 6 FBKGND2,
FBKGND1
Ground Kelvin feedback (Channels1&2)
3 DCMP Internal mode selection. This pin must be grounded for proper device
operation.
4, 7 FBKOUT2,
FBKOUT1
Switching feedback (Channels 1 & 2)
5 VPWR Test pin. Must be left floating.
8 HMUTE Logic output. A logic high indicates both amplifiers are muted, due to the
mute pin state, or a “fault”.
9, 12 Y1, Y2 Non-inverted switching modulator outputs.
10, 11 Y1B, Y2B Inverted switching modulator outputs.
13 NC No connect
14 OCD2 Over Current Detect input.
15 REF Internal bandgap reference voltage; approximately 1.2 VDC.
16 OCD1 Over Current Detect input.
17 VNNSENSE Negative supply voltage sense input. This pin is used for both over and
under voltage sensing for the VNN supply.
18 OVRLDB A logic low output indicates the input signal has overloaded the amplifier.
19 VPPSENSE Positive supply voltage sense input. This pin is used for both over and
under voltage sensing for the VPP supply.
20 AGND Ground.
21 V5 5 Volt power supply input.
22, 27 OAOUT1, OAOUT2 Input stage output pins.
23, 28 IN1, IN2 Single-ended inputs. Inputs are a “virtual” ground of an inverting opamp
with approximately 2.4VDC bias.
24 MUTE When set to logic high, both amplifiers are muted and in idle mode.
When low (grounded), both amplifiers are fully operational. If left floating,
the device stays in the mute mode. Ground if not used.
25, 26 BBM1, BBM0 Break-before-make timing control to prevent shoot-through in the output
MOSFETs.