Specifications

.13 Cross Fade
This specifies the cross fade playback mode. The cross fade time range is 0-10 seconds ( 0 seconds sets the cross
fade off ).
The cross-fade reproduction is controlled by the Cross Fade Play command or the Cross Fade Disc Reserve
command.
Only Stop, Request System Status, Power Off, Request CPU Version, and Request Error Status
commands are acceptable during cross-fade reproduction.
When the door is opened in the Cross Fade mode, the Cross Fade mode is turned off and the Single Zone mode is
set.
bytebit 7 6 5 4 3 2 1 0
0
STX 02h
1
Command code A
2
Cross fade time specification 09A0OFFA10 sec
3
ETX 03h
4
BCCH high-level
5
BCCL low-level
Answers returned
bytebit 7 6 5 4 3 2 1 0
0
STX 02h
1
Reply code A
2
Answer code
3
ETX 03h
4
BCCH high-level
5
BCCL low-level
Special condition
· The unit plays back in cross fade only when in the single zone mode.
· This command is valid only when the system status is Disc Sense (2), Door Opening (4), or
Disc Nothing (5) after the system status is open or Disc Sense Complete (3) when the zone status is No
Disc (A) or Stop (B).
Other